How to Tape and Mud Drywall Seams – One of the essential skills necessary for the application of drywall is knowing how mud and tape drywall. The process mudding drywall and registration is a bit complicated, but it is not that hard to do. The right tools and proper techniques will make the task much more straightforward than it seems. Here is how the mud and tape drywall.
How to Tape and Mud Drywall Seams
Step 1 – Preparation
Make sure all screws and nails are fixed below the surface drywall. Use the larger knife 6-inch taping for protruding nail heads checked by running on the leaf surface. Make sure the surfaces are clean as well. Use a clean cloth to wipe off dust or debris which may affect the bonding effect of the adhesive of the leaf surface.
Step 2 – apply tape
Apply the strip of drywall to joints drywall. Start from one end of the joint and to work the tape to the end using your hands to press firmly adhesive to the leaf surface. The tape should be centered approximately in the middle of the joint.
Step 3 – Mudding joints
Place a good quantity of joint compound on the mud shelf. Take the registration knife 6 inches and place a small amount of joint compound to both. Apply a thin layer on the strip of drywall at a time until the entire strip is covered with the compound. Then take the knife and run it on the compound to smooth against the surface of the drywall.
Step 4 – Cover the nail holes
Covering the nail holes with the compound is completely easy. Simply place a small amount of joint compound over the smallest knife recording 3 inches and run the compound above the holes. Scrape off the excess material once or twice.
Step 5 – joints, corners
Run the tape on the central joint of the corners in the same manner as other joints. Make sure the belt is centered on the joint. Applying the joint compound thus. Let the first coat dry.
Step 6 – The application of the second and third final coating
Before applying the second layer of slurry on the joints and the nail holes, sand, and the edges of the first layer surfaces on the belt of the same in place. Apply a thin layer of mud on the joints and holes with a large knife to expand coverage. Let dry and sand the surface again before applying the third and final coating. Make sure that the final coating is wider than the second.
Step 7 – Finishing Touches
Allow drying the coating and sand surfaces once again able to them in place. Wipe with a clean cloth or rag to remove dust and debris and apply paint as desired.